Vacuum filling and pressure dosing system for molten aluminium

The Al Serve System was developed by HOEI METAL Co.Ltd and is distributed on selected markets by Lethiguel. This system, incorporating a transport ladle, enables inplant transportation of liquid aluminium and holding furnace refilling operations.

Overview of the pressure dosing system

Molten aluminium is transferred from a melting furnace into a dedicated pressurizing transport ladle and then to any die casting machine without any contact with air.

Pressure dosing system can be embedded on forklift or not, several configurations are available to arrange the right solution in the right place, for the right application.

Liquid metal transfer with a sealed ladle offers an important safety during transits (no splashes) and drastically brings down the oxide and dross formation.

Filling of transfer ladle generates an average of 5.2 kg/Ton of oxides with standard pouring system, down to 0.9 kg/Ton with Al Serve vacuuming system.

4 Steps

molten aluminium transport ladle

Preheating of molten aluminium transport ladle

The ladle is pre-heated before use. Caution: in general, when pre-heating is neglected, thermal issues can occur! Lethiguel and Hoei have conducted tests to determine the perfect sintering process for Al Serve.

Filling molten aluminium from a melting furnace to a ladle

Molten aluminium from the melting furnace is drafted through a pipe by decompressing the inside of the transport ladle. This transfer is automatically stopped by detecting the level of molten metal in the transport ladle

Molten aluminium filling system manufacturer
vacuum filling and pressure dosing system for molten aluminium Al Serve

Transfer of molten aluminium from the transport ladle to a die casting machine

By pressurizing the inside of the transport ladle with compressed air, molten aluminium is discharged through a pipe. The applying pressure is controlled depending on the weight of molten metal inside the pot. Again, the low limit of molten metal inside the transport ladle is detected with a measuring device. Alternatively, the process can be automatically stopped with an alarm when the die casting machine reaches full capacity.

Pressure dosing of molten aluminium’s assets

  • Safer system than a conventional tilted ladle: no lifting up high and no rotation needed. •
  • Reduced amount of oxide inclusions as the metal’s exposition to air is minimized. •
  • Scrap drastically reduced (5kg/ton)
  • Easy operation that does not require skilled labour
  • Both filing and dosing operations are processed with one device which improves efficiency and productivity.
Manufacturer of foundry pressure dosing system for molten aluminium